Lightning Arrestor

What is a Lightning Arrestor?

Introduction

A lightning arrestor is a device used in electrical power systems and telecommunications systems to protect the insulation and conductors of the system from the damaging effects of lightning. The typical lightning arrestor has a high-voltage terminal and a ground terminal.

Watch the Video

Function of Lightning Arrestors

Protection: Provides a path to ground for high voltage surges, typically caused by lightning, thus protecting the electrical systems from damage.
Insulation Safety: Helps in maintaining the integrity of insulation by diverting the lightning surge to the ground.
Voltage Control: Controls the voltage level within the system by providing a low impedance path to ground.

Comments

Understanding the Various Types of Pipelines and Their Construction Methods

Understanding the Various Types of Pipelines and Their Construction Methods Pipelines are essential infrastructure for transporting liquids, gases, or slurries across vast distances efficiently and safely. Here’s an overview of 16 types of pipelines commonly used in various industries, along with their construction methods: Oil Pipelines: Construction Method: Oil pipelines are typically constructed using steel or, in some cases, high-density polyethylene (HDPE) pipes. Construction involves trenching, welding, and coating to prevent corrosion. Gas Pipelines: Construction Method: Gas pipelines use materials like steel or thermoplastic pipes. Construction methods include trenching, welding, and the installation of compressor stations along the route for maintaining pressure. Water Supply Pipelines: Construction Method: Water supply pipelines can be made from various materials suc...

Calculation of Grease Applied in Bearings - Are You Doing It Right?

Calculation of Grease Applied in Bearings - Are You Doing It Right? In industrial maintenance, one of the most overlooked yet critical aspects is the proper lubrication of rolling element bearings. Over-greasing or under-greasing can both be equally damaging, leading to premature failure, increased friction, and downtime. So how do you calculate the right amount of grease? is: A widely accepted formula for initial grease quantity Grease (g)=DxB×0.005 Where: ◆ D = Outer Diameter of the bearing (in mm) B = Width of the bearing (in mm) ◆ 0.005 = Empirical constant (for standard applications) Example: For a bearing with D = 100 mm and B = 25 mm: 100×25×0.005=12.5grams This formula helps ensure a balanced grease film without causing churning or heat build-up. 👉Initial fill = calculated value 👉Relubrication = only 1/3 to 1/2 of free space 👉Right lubrication = longer bearing life + smooth operations! Tip: Always refer to the bearing manufacturer's specifications (SKF, FAG, NSK, etc.)...

Fire Pump Rooms that pass first time design once, test cleanly

Fire Pump Rooms that pass first time — design once, test cleanly 🎯 Purpose Provide code‑reliable water flow and pressure to sprinklers and standpipes during fire. Operate under loss of power and single faults, without operator intervention. (NFPA 20, NFPA 13, NFPA 14) 🧩 Anatomy / Components • Fire pump (diesel or electric) with listed controller. • Suction from tank with anti‑vortex plate and air‑release at high point. (NFPA 22) • Eccentric reducer flat‑on‑top and long, straight approach to the eye. • Discharge check + OS&Y gate, relief to safe drain/test header. • Jockey pump + pressure switch to maintain setpoint. • Test header/flowmeter line, gauges on suction/discharge, trench to drain. • Signals to FACP: pump run, controller trouble, phase loss, low fuel. 📐 Setpoints & Specs • Suction velocity ≤ 1.8 m/s; straight length ≥ 5–10 × suction Ø. • Anti‑vortex plate diameter ≈ 2 × outlet; elevation ≥ 0.5 × outlet above floor. • Normal pressure band: jockey ± ...

Preventive maintenance of MEP Equipment

Search This Blog